How to Reset Rockspace Wi-Fi Extender in 2023

If you have forgotten the admin password for the RockSpace device, or if an attempt to update the firmware has failed, or if there is a problem with the performance of the hardware and you want to conduct a fresh installation, then you will need to reset the RockSpace device. However, it is essential to keep in mind that when you carry out the reset procedure, the settings of the extender will be reverted to their original, factory-default configuration. Because of this, all of the customised settings will be deleted, and the system will need to be reconfigured. As a result, it is not recommended to reset an extender unless it is absolutely necessary, and even then, only if you are familiar with how to reconfigure the device. If you are looking for comprehensive information on how to reset the Rockspace wifi extender, the following page will be of use to you:

How to Reset Rockspace Wi-Fi Extender

What Do You Need in Order to Reset?

To return the rockspace range extender to its original state, you will need a few things, including the following:

A Source of Power to Plug in the Rockspace Range Extender
Something very small, like a paperclip, a toothpick, or a pen.
Rubber Gloves for safety (Optional)
default ip address or web address (For soft Reset Only)
A Cable for Ethernet Internet Cable, also known as an optional need in the event that the console needs to be reset.

Let’s get started with the hard reset procedure now.

Reset Rockspace Wi-Fi Extender

1. After you have successfully plugged the rockspace range extender into a power outlet, it is time to turn it on.

2. Locate the key that may reset the rockspace extender, and then make use of it.

3. You can press and hold the reset key for the next ten to fifteen seconds using a toothpick, a paperclip, or a pen, among other possible implements.

4. You can stop holding the reset key in place after all of the lights on the rockspace extender begin flashing at the same time. After that, you should wait ten seconds.

5. Simply giving the rockspace range extender a new start will force it to reset to the default settings that were set for it when it was manufactured.

What is the default password for the Rockspace wifi extender?

The default username and password for the range extender’s administrative interface is admin. Because of concerns about security, we suggested making the change.

Does a wifi extender use the same password as your router?

The repeater will typically have its own network name (SSID) and password. This SSID will be distinct from the SSID of the router and any other amplifiers located within the home. Additionally, the repeater’s SSID and password will not be automatically synchronised when the SSID of the other device is updated.

Why won’t my wifi extender connect to my router?

You will need to do a factory reset on your Wi-Fi extender if it is unable to establish a connection with the Wi-Fi router. It’s possible that different brands of extenders will have different placements for the button that resets the device. You’ll find the button to reset your extender on the back of the device; to do so, push the button with a needle for ten seconds.

Why is my wifi extender not accepting my password?

In the event that the password is entered incorrectly, there is a possibility that the extender will also receive an erroneous password. If, after inspecting the LED lights, you discover that they do not indicate that the extension is connected to the router, you will need to reset the extender and check whether the password was entered using lower case or upper case letters.

Do devices automatically connect to WiFi extender?

The vast majority of recently released WiFi gadgets automatically join to the network with the highest available signal strength. It’s possible that some WiFi devices can’t accomplish this at all, or that they need further configuration in order to. Before moving on with the process, it is strongly suggested that you check the WiFi connection capability of your devices.